Disa Co-To-Co - Vodavi STARPLUS STSe Operation Manual

Direct Inward System Access (DISA)

DISA CO-to-CO

Description
The DISA CO-to-CO (or Conference) option on the CO line governs a DISA caller's ability to
access other outside lines. CO lines must have DISA CO-to-CO enabled to allow a DISA caller
to establish an outgoing CO-to-CO connection. This allows for specific CO line access
restriction on DISA calls. A station with Conference enabled can initiate a conference on CO
lines regardless of the CO line conference marking.
The CO line conference flag affects a DISA caller's ability to access outgoing CO lines as
shown in the following table:
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
4. Press the DISA CO-TO-CO flexible button (Button #4).
5. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
STARPLUS STSe - Programming & Operations Manual
Table 2-9: CO Line Conference Flag
Incoming DISA CO
CO-to-CO Enabled
CO-to-CO Enabled Call Allowed
CO-to-CO Disabled Call Denied
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
E N T E R B U T TO N N U MBE R
XXX-XXX = CO Line Range
D I S A CO- TO- CO
E N AB LE D
DISA Caller Attempts to Access
CO-to-CO Disabled
Call Denied
Call Denied
0-1
2-131
Features and Operation
August 2005