Vodavi STARPLUS STSe Operation Manual page 128

2-104
Features and Operation
To exit a Conference (controller only) perform ONE of the following:
1 -- Press ON/OFF button to ON, press MUTE, then replace handset (
To exit a multi-line conference in progress:
2 -- Press the HOLD button to place outside parties on hold. The Hold Timer starts. If one
of the two parties is internal, that party is dropped.
3 -- Either press CONF and hang up, press the ON/OFF button, or use the Soft Key's EXIT
option to leave the other conference parties still connected in an unsupervised
conference. The CONF button flashes and the timer starts. There is a warning tone before
the other parties are dropped.
To re-enter a Conference:
When the controller re-enters the conference, the disconnect timer is reset.
Lift handset to re-enter a monitored conference.
To re-enter a conference placed on hold, repeat steps for establishing a conference.
To re-enter an unsupervised conference, lift handset and press flashing CONF button or
use the Soft Key's RE-ENTER option. CONF button lights steady; a confirmation sounds.
To terminate a Conference, a conference initiator who is active in the conference
must:
Replace handset or push ON/OFF button to OFF.
To terminate an Unsupervised Conference:
Press the flashing CONF button or use the Soft Key's END option while on-hook, all parties
are dropped.
To terminate a party from a Conference (while in conference):
1. Press line button of party to drop.
2. Replace handset or press ON/OFF button.
3. Lift handset or press ON/OFF button, then press flashing CONF button.
SINGLE LINE TELEPHONE
To set up a Conference with one external and one other internal station:
1. Make outside call.
2. Press the FLASH button to put the call on hold.
3. Dial number of internal station you wish to add.
4. When that station answers, press the FLASH button again, all three parties are connected.
To set up a Conference with Personal Park:
1. While connected to an outside line, press the FLASH button. The intercom dial tone
sounds.
2. Dial [438]. The first call is placed in personal park.
3. Dial desired number for second call.
4. Press the FLASH button. The Intercom dial tone sounds.
5. Dial [664]. All three parties are conferenced.
6. Hang up to terminate the conference.
STARPLUS STSe - Programming & Operations Manual
Conference
).
to monitor conference
August 2005