CO Ring Detect Timer
Programming Steps
1. Press the CO PORTS/CODES flexible button (FLASH 85, Button #4). The following
message displays:
2. To print the CO Port Parameters and Feature Codes, press the HOLD button. The following
message displays:
When the system finishes sending the requested information to the printer, a
confirmation tone sounds.
CO Ring Detect Timer
Description
The CO Ring Detect Timer controls the time necessary to detect an outside line ringing into
the system. The duration of the ringing signal from the CO or the PBX is matched with ringing
detection circuitry in the STSe. The ring detect can range from 200 ms to 900 ms programmed
in 100 ms increments. This timer helps prevent false ringing.
Programming Steps
1. Press the CO RING DETECT TIMER flexible button (FLASH 01, Button #11). The following
message displays:
2. Enter a valid number on the dial pad that corresponds to 2-9 (200 ms to 900 ms).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... CO Ring Detect Timer is set at 3 (300 ms).
STARPLUS STSe - Programming & Operations Manual
P R I NT CO P O R T S / CO DE S
P R ES S HOL D
P R I NT IN G CO P O R T
CO R I NG DE T EC T
3
Features and Operation
2-9
2-99
August 2005