Exception Code Table; Route List Table; Insert/Delete Table; Daily Start Time Table - Vodavi STARPLUS STSe Operation Manual

B-8
Appendix B - Least Cost Routing

Exception Code Table

Description
The Exception Code Table is used for operator calls and any other calls that use a one- or
two-digit entry, rather than a three-digit area code.
Programming Steps
1. Press EXCEPTION TABLES flexible button (FLASH 75, Button #3). This message displays:
2. Press the HOLD button to save the entry. A confirmation tone sounds and the display
updates.
3. Press FLASH 75, Button #3 again for further entries. Up to 20 Exception Codes may be
programmed in this table.

Route List Table

Description
Each of the 16 Route List Tables available contains four Time Period Routing Lists, one for
each of the 4 daily start time periods. Within each Time Period Route List up to 7 CO (outside)
line groups and their corresponding Insert/Delete table, if any, and LCR Class Of Service
Priority are programmed on a per line group basis.
When routing a CO call through LCR, CO Line groups are accessed in sequence so that the
first line group entered represents the least costly (and first selected) and the last line group
entered represents the most costly (and last selected).
The Route List Table references many other tables when processing a call for routing. First,
the Daily Start Time Table is referenced to determined what start time entry should be
checked in the Weekly Schedule Table. The corresponding entry in the weekly schedule table
depending on the day of the week then determines which Time Period Route List should be
used within the Route List Table.
The system then begins to check for idle lines in the first entered CO line group and proceeds
until an idle line is found. While it is searching for an idle CO line the Station LCR COS is
checked against the entries for LCR COS Priority of the specific CO line groups (see LCR COS
Priority explanation).
When an idle CO Line is found with a LCR priority equal to or higher than the stations LCR
COS, a final check should be made to see if an Insert/Delete Table should be referenced.
When all of the tables and entries are checked, the system then processes the call on the
outside CO line.
STARPLUS STSe - Programming & Operations Manual
E XC EP T I O N COD E TA B L E
E N T E R XX RR H O L D
= [0] to remove code from table, [1] to add code to table
XX = Exception codes for single digit codes, press MUTE button as 2nd digit.
(The [ ] may be entered as the 1st digit only.)
RR = Route Table Number 00–15
Programming LCR Tables
August 2005