Deny Table - Vodavi STARPLUS STSe Operation Manual

Toll Restriction

Deny Table

Description
Each Deny Table contains ten bin numbers. Each bin number may be up to eight-digits
including {Do Not Care} digits. Entries in the Deny Table represent numbers or codes that are
to be denied or restricted. Common entries would be [1] for restricting all [1+] type of calls.
Exceptions to this restriction would be entered into the Allow Table.
Deny Table A is referenced and searched only after the Allow Table A is checked when
Station COS is 2 and CO Line COS is either 1 or 2.
Deny Table B is referenced and searched only after the Allow Table B is checked when
Station COS is 3 and CO Line COS is either 1 or 3.
When Station COS is 4 and CO Line COS is 1, both allow tables are looked at first (Allow
Table A first, then Allow Table B) then both deny tables (Deny Table A first, then Deny
Table B).
- Do Not Care digits specify that the system should consider any digit dialed in that
position as a match. Do Not Care digits should not be entered as the last digit in an entry.
- Search Special Table commands cannot be entered into the Deny tables.
Programming Steps
1. Press the DENY TABLE A or DENY TABLE B flexible button (FLASH 70, Button #2 or #4).
The following message displays:
2. When the first two bin locations are displayed, enter the 2-digit bin number (01–10) of
the bin to be programmed.
3. Enter the deny code:
[0–9], [ ], [#] = Corresponding deny digits numbers
MUTE = Do Not Care digit
4. Press HOLD to save the entry. A confirmation tone sounds and the display now updates.
5. When all entries for one table are complete, press the flexible button for the next table.
To erase a bin number:
1. Enter a valid bin number.
2. Press the HOLD button.
STARPLUS STSe - Programming & Operations Manual
D E NY TA B L E A
0 1 E
Features and Operation
02E
2-323
August 2005