Pbx Dialing Codes - Vodavi STARPLUS STSe Operation Manual

2-60
Features and Operation
Operation
While connected to an outside line (PBX/Centrex):
1. Press the FLASH button. Receive transfer dial tone.
2. Dial a PBX/Centrex station number.
3. Hang up to complete the transfer.
SINGLE LINE TELEPHONE
While connected to an outside line (PBX/Centrex):
1. Press the FLASH button. Receive transfer dial tone.
2. Dial [660].
3. Dial a PBX/Centrex station number.
4. Hang up to complete the transfer.

PBX Dialing Codes

Description
Five 1- or 2-digit PBX access codes can be programmed into memory. When dialed, these
codes signal the system so toll restriction is applied at the next dialed digit. When a single
digit code [9] is entered, it must be followed by [#] as the second digit. Refer to
on page 2-5.
Flash 40
Programming Steps
1. Press FLASH and dial [12]. The following message displays:
2. Enter valid numbers (one right after the other) on the dial pad, up to ten digits. If a single
digit code is required, enter the code followed by [#].
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
4. To delete a code, enter [#] [#] and press HOLD.
DEFAULT ... No PBX dialing codes are assigned.
Conditions
»
Lines must be programmed as PBX lines before these codes apply.
STARPLUS STSe - Programming & Operations Manual
If 911 is enabled for a PBX trunk using Centrex, entry one in Flash 12 (of [9] + [#])
will insert the Centrex 9 (not LCR).
Quick Reference
Page A Button #2 PBX/CO (refer to
P B X D I A L COD E S
# # , # # , # # , # # , # #
"CO / PBX Programming" on page
Centrex/PBX
"911 Feature"
2-57).
August 2005