Voice Mail Disconnect Table - Vodavi STARPLUS STSe Operation Manual

Voice Mail Outpulsing Table

Voice Mail Disconnect Table

Description
A disconnect signal can be programmed into the STSe system to notify the VM system that a
call has been abandoned. This is accomplished through in-band signaling. If a CO or Intercom
disconnect signal is detected, the STSe system sends a series of DTMF digits programmed in
the voice mail disconnect table to the voice mail port. This can be any digit stream up to
12 digits including [ ] and [#].
This table serves all eight voice mail groups. When no digits are programmed in the
disconnect table, silence is provided to the voice mail port followed by busy tone to aid the
voice mail system to recognize that the caller has abandoned the call.
The STSe system provides Loop Supervision monitoring while a CO call is connected to a port
designated as voice mail and passes the Supervision to the voice mail.
Programming Steps
1. Press the DISCONNECT TABLE 8 flexible button (FLASH 66, Button #9). This table
number is used for the voice mail disconnect signal.
2. Enter up to 12 digits used for the disconnect signal, including [ ] and [#], TRANS button =
pause.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... There are no entries in the Disconnect Table (Table #8).
STARPLUS STSe - Programming & Operations Manual
Loop Supervision must be enabled on the CO lines (in CO Line programming) for
the VM Disconnect feature to operate.
VO ICE D I S E
M A IL
2-353
Features and Operation
August 2005