Vodavi STARPLUS STSe Operation Manual page 346

2-322
Features and Operation
For an entry that references the Home Area Code table (Special Table 4) the entry may also be
entered to expect or not expect a leading digit [1]. In fact, in some cases it may be desirable to
enter both of the following entries:
Leading Digit [1] -- Enter [BB] [1] [DDD] {S}
and/or,
Non-Leading [1] -- Enter [BB] [DDD] {S}
BB = Bin number (Bin 20)
DDD = Do Not Care digit (three entries, MUTE button)
{S} = Search Special Table Command (TRANS button)
Programming Steps
1. Press the ALLOW TABLE A or ALLOW TABLE B flexible button (FLASH 70, Button #1
or #3). The following message is shown on the display telephone:
The first two bin locations display.
2. Enter a valid bin number (01–20) of the bin to be programmed.
It is recommended that:
Bin 17 be reserved for an entry that references SPECIAL TABLE 1
Bin 18 be reserved for an entry that references SPECIAL TABLE 2
Bin 19 be reserved for an entry that references SPECIAL TABLE 3
Bin 20 be reserved for an entry that references Home Area Code Table, SPECIAL TABLE 4.
3. Enter the Allow Code.
[0–9], [ ], [#] = Corresponding allow digits (numbers)
MUTE = Do Not Care digit (D)
TRANS = Search Special Table (S)
4. Press HOLD to save the entry. A confirmation tone sounds and the display now updates.
5. When all entries for one table are complete, press the flexible button for the next table.
To erase a bin number:
1. Enter a valid bin number.
2. Press the HOLD button.
STARPLUS STSe - Programming & Operations Manual
If both leading digit [1] and non-leading digit [1] entries are made to reference
the same table, it is necessary to place the leading digit [1] entry ahead of the
non-leading digit [1] entry in the Allow Table.
A L LO W TAB LE A
0 1 E 02E
Toll Restriction
August 2005