Vodavi STARPLUS STSe Operation Manual page 374

2-350
Features and Operation
Conditions
»
If you hang up without terminating the record function, the system performs the exit
procedure as described in step 3 above.
»
If you press the TRANS, CAMP ON, MSG, or FWD buttons during recording, pressing the
button is ignored.
»
During the recording setup, pressing the CONF button is ignored.
»
If a VM port is not available when you want to record, you receive the following display
(lasts six seconds):
(You may retry after the display extinguishes.)
»
In the recording mode, pressing the CONF button lets you add members to the recording
(conference). Normal conference operation/conditions apply.
»
If the FLASH or HOLD button is pressed during the recording, the recording is terminated.
»
If you press the record button while in a two-party conference, it is recorded. If you press
the button a second time, the conference ends and the call returns to a two-way
conversation.
»
Only one active recording per station is allowed.
»
If a conference is being recorded and the conference master exits, the recording stays
active. The recording stops if the initiator re-enters the conference and ends it, removes
the record function, or the conference ends on its own.
»
Only the initiator of a conference can invoke/remove the record function during a
conference.
»
A conference warning tone is not given to conference members, if the initiator is
recording the conference and record tone is disabled.
»
Recording is not allowed for a station that is barged in, Executive Overridden, or on an
active OHVO call.
»
An Unsupervised Conference Call can be recorded.
»
One-Touch Recording uses Table 7 from the Voice Mail Outpulsing Table (refer to
page
»
Recordings made using the Soft Key are stored in VM group 440.
»
This feature only applies to digital voice mail systems.
STARPLUS STSe - Programming & Operations Manual
R E COR D IN G U N AVA IL A B L E
M M M DD Y Y
2-351).
Voice Mail One-Touch Recording
0 0 : 0 0 a m
August 2005