Station Id Lock - Vodavi STARPLUS STSe Operation Manual

Station Identification
7. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
8. If a Virtual Station is used, a system reset is required.
DEFAULT ... The system auto-detects all Vodavi telephone types, DSS console, and Door Box.
Conditions
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
»
Auto-detect will not work if the Station ID Lock feature is enabled. Refer to
Lock" on page

Station ID Lock

Description
The Station ID Lock feature provides a means for the installer/programmer to lock the station
ID of all stations in the system. After locked, attempts to plug unlike devices (e.g., a DSS into a
24-button port) results in the device not working. This feature is designed to prevent loss of
station programming that results when a different station type is plugged into a port already
designated as another station type.
To change the Station ID with the Station ID Lock feature enabled:
1. Enter programming mode and disable the Station ID Lock feature.
2. Plug the new device type into the jack. The set is automatically identified.
3. Enter programming mode and enable the Station ID Lock feature.
-or-
Use FLASH 50, Page B, Button #1 programming to manually set station ID, without disabling
Station ID Lock.
Programming Steps
1. Press the STATION ID LOCK flexible button (FLASH 06, Button #8). The following
message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... Station ID Lock feature is disabled.
STARPLUS STSe - Programming & Operations Manual
When redesignating a station from an SLA (identified by code 015) to an STSe
24-Btn Phone (normally identified by [0]), you must enter [000].
When designating a station as a DSS Console with map 1, map 2, or map 3,
you must follow the entry with the station number for which the DSS is to be
associated. Refer to "Station ID for DSS/BLF Console With Map" on page
2-285.
STAT ION LOCK
D I S A B LE D
Features and Operation
0-1
2-285
3-21.
"Station ID
August 2005