Vodavi STARPLUS STSe Operation Manual page 380

2-356
Features and Operation
Receiving an incoming tone ringing Intercom or CO call ...
.
SINGLE LINE TELEPHONE
The volume control on the Vodavi Single Line Telephone is located on the right side of the
telephone. The slider switch options are HI for loud volume, LO for low volume, and OFF to
turn the ringer off. Two-line models have a volume switch for each line. Certain models do
not have an OFF option.
Speakerphone models have a sliding volume switch to adjust speakerphone volume. Slide
the switch toward you for lower volume or away from you for increased speakerphone
volume.
Each model has a volume button that can be pressed to increase or decrease the handset
volume.
The B/Z ringer switch of 2700-series SLTs is located on the bottom of the telephone near the
line jacks. This switch should be set to the Z mode for business/hospitality applications and to
the B mode for residential applications.
For single line telephones that are not equipped with a volume control slider switch or to
increase the volume greater than that allowed by the slider switch, use the following steps.
While on a CO line call or an intercom call:
1. Press the FLASH button.
2. Dial 638.
3. Dial a valid number (0-9) to select a volume level.
-or-
Use [
Volume selections relate to a baseline volume. The options are:
0 = -15DB
1 = -12DB
2 =
3 =
4 =
4. Press the FLASH button to return to the call.
STARPLUS STSe - Programming & Operations Manual
S P E AK ER RI N G
M MM DD Y Y
The MSG light and the Line In Use (LIU) LEDs will not operate when set in the B ringer
mode.
]
or [#] to scroll to increase or decrease volume level.
5 = 0DB
6 = 3DB
-9DB 7 = 6DB
-6DB 8 = 7.5DB
-3DB 9 = 9DB
[#########]
H H : MM a m
Volume Control
August 2005