Vodavi STARPLUS STSe Operation Manual page 238

2-214
Features and Operation
Operation
At an idle station:
1. Dial the Keyset Mode code [648] on the dial pad,
-or-
Press the preprogrammed KEYSET MODE button, the following displays:
2. Press [ ] to scroll through the keyset modes.
3. Press [#] to scroll through the baud rates.
4. Press the HOLD button to save the desired entries.
SINGLE LINE TELEPHONE
Not applicable
Conditions
»
Telephone must be in AT command mode to process AT commands.
»
CTI information is still sent out the RS-232 port in AT command mode.
»
The ATD command is always accepted by the telephone while it is in the AT command
mode. ATHX is accepted only if enabled.
»
ATZ is always enabled if station is in the ATD or ATH command mode.
»
ATD accepts W to indicate a pause command (ATDT9W9982200).
»
ATH or ATH0 causes an on hook event. ATH1 must be specified to go off hook.
»
AT or ATZX (X = 0 or 1) is the modem reset/initialize command. When these commands
are sent to the keyset, it returns OK in ASCII format.
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
»
Either the Wanderer or the CTI module can be connected to a station, but not both
simultaneously.
STARPLUS STSe - Programming & Operations Manual
I N ACT IV E
M O D E = S AV E= HO L D
2400
BAU D = #
Keyset Mode
August 2005