Keyset Button Test; Dss Led/Button Test; Flash Rates - Vodavi XTS-IP Installation Manual

Telephone Troubleshooting

Keyset Button Test

1. Press a keyset button to turn on the LED and display an LCD message identifying the
button number.
Each time the selected button is pressed it sequences through the flash rates available.
2. Press the dial pad keys to display an LCD message that indicates which digit was pressed.
Depressing the H-T-P switch from one position to another displays one the following
words: H_POS, T_POS, or P_POS.
3. Test LEDs independently of the Keys by pressing the flexible LED button.

DSS LED/Button Test

When the DSS test is selected and a DSS test is invoked, ALL DSS units associated with the
keyset are placed in the test mode.
If no DSS unit is associated with the keyset, the keyset display indicates NO DSS. The DSS LED
test causes all the LEDs to light steady. All LEDs remain lit steady until a DSS flexible button is
depressed. Pressing a DSS button turns on the DSS button LED and displays an LCD message
on the associated keyset identifying the DSS button number (01 to 48). In addition, it turns off
the previously selected flexible LED.
Conditions
»
Test Mode interrupts the normal operation of a keyset or DSS.
XTS-IP - Installation Manual
PRESS KE YS ET B U T TO NS
DIGIT1
Table 4-1: Flash Rates
Button
01
02
03
04
05
06
07
08
09
10
11
12
13
14
PRESS DSS BUT TONS
P R ES S D SS B U T TO N S
BTN01
Chapter 4 - Maintenance and Troubleshooting
<--------
ipm
On Steady
30 Flash
60 Flash
60 Double Wink
240 Flash
240 Flutter
480 Flash
480 Flutter
15 Flash
120 Flash
120 Flutter
30 Double Flash
480 Double Wink
480 Double Flash
< - - - - - - - - - -
<----------
Type
December 2005
4-5