Vodavi STARPLUS STSe Operation Manual page 35

Account Codes
To assign Verified Account Codes:
1. Press FLASH and dial [31]. The following message displays:
2. Press the ACCT CODE flexible button (Button #1). Enter up to 12 digits
(0-9, *, #). [*] represents a do not care digit. The system ignores all digits after this digit
when entering an account code. The [#] represents a single do not care digit.
3. Press the CLASS OF SERVICE flexible button (Button #2). Enter a 2-digit Class of Service
Number (1-7) that corresponds to Class of Service 1-7. The first digit represents Day COS
and the second digit represents Night COS.
4. Press HOLD to complete the entry. A confirmation tone sounds.
DEFAULT ... No Account Codes are assigned.
To delete the currently displayed Verified Account Code:
1. Press the DELETE CODE flexible button (Button #3) to delete the entire account code
entry.
2. To display the next account code on the LCD, press the NEXT flexible button
(Button #18).
3. To display the previous account code on the LCD, press the PREVIOUS flexible button
(Button #19).
To erase previously entered digits:
1. Press the ERASE DIGITS flexible button (Button #4)
2. Each press of the button erases one digit. Continue until all desired digits are erased.
3. Re-enter the correct digits, then press HOLD to complete the entry. A confirmation tone
sounds.
STARPLUS STSe - Programming & Operations Manual
ACCT
XXXXXXXXXXXX
ACCT = Up to 12-digit account code
COS = Class of Service for account codes
Existing account code entries display in numerical order from lowest to highest.
If an existing account code displays on the LCD when FLASH 31 is initially
entered, the programming procedure creates a new account code, but does not
delete the account code initially shown. If the intent is to change an existing
account code from one number to another, perform the assignment procedure
and delete the undesired account code entry by following the procedure in the
following section.
Features and Operation
COS
##
2-11
August 2005