Call Forward Display; Call Forward - Preset - Vodavi STARPLUS STSe Operation Manual

2-34
Features and Operation

Call Forward Display

Description
When any type of station call forwarding is invoked, the LCD display normally indicates the
call forwarding mode at all times. This feature has modified the LCD forwarding display to
make the call forwarding mode display optional. This feature is enabled/disabled in admin
programming on a system-wide basis. The call forward status is stored in a battery protected
area of memory.
Programming Steps
1. Press the CALL FWD DISPLAY STATUS flexible button (FLASH 06, Button #4).
2. Enter a 0 or 1 on the dial pad to enable/disable Call Forward Display.
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... Call Forward Display is enabled.

Call Forward - Preset

Description
The Call Forward Preset feature allows the system database to be configured so that
incoming CO Lines, which are programmed to ring at a particular station, can be forwarded
elsewhere in the system predetermined by programming. This feature is active if the station
ringing is not answered in a specified time, and is particularly useful in overflow applications
in which a Voice Mail or Auto Attendant may be in use.
The following Call Forward - Preset types are detailed in the next several sections:
Preset Call Forward - Voice Mail, UCD, or Hunt Groups -- CO Lines can be Preset
Forwarded to ring to one of the group types in the system (Hunt, Voice Mail, or UCD). Each
time the Preset Forward Timer expires (a total of 5 attempts), the group is checked for an idle
station.
Preset Call Forward - Off-Net -- CO Lines can be preset forwarded to ring Off-Net via speed
dial from any station. After the expiration of the preset forward timer, the system selects an
idle CO line, dials the off-net location, then connects the two CO lines.
Preset Call Forward - Per CO Line -- The Preset Call Forward feature allows each CO line to
be preset call forwarded on a per CO line basis. This allows a CO line to initially ring at
multiple stations and forward to a predetermined destination. The destination can be a
station or Hunt Group. Each CO line has a Preset Forward Timer. Each CO line also has a VMID
field to allow specific VM digits to be sent when a CO line forwards to a VM group. Feature
applies to initial CO ringing lines only.
STARPLUS STSe - Programming & Operations Manual
C A LL FW D D I S P L AY
E N AB LE D
Call Forward - Preset
0-1
August 2005