Ring Delay Timer - Vodavi STARPLUS STSe Operation Manual

ICLID Programming

Ring Delay Timer

Description
The Ring Delay timer was added to the STSe to accommodate ICLID interface requirements.
The Ring Delay timer is started whenever a CO Line detects incoming ringing. When the timer
expires, CO line ringing is detected by digital telephones and SLTs.
The purpose of this timer is to wait until after the first ring cycle to be detected by the digital
system so the ICLID information is passed down the CO line prior to being answered. In some
cases, it may be necessary to set the Ring Delay Timer to five seconds so all the ICLID
information is received from the Central Office. The Ring Delay Timer setting is variable from
00-20 seconds.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press Button #21 to select Page C. The display updates. The following message displays to
indicate current programming of that line or group of lines:
4. Press the RING DELAY TIMER flexible button (FLASH 40, Page C, Button #2). The
following message displays:
5. Enter a valid number on the dial pad (00–20) which corresponds to 00-20 seconds.
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Ring Delay Timer is set at 00 (disabled).
STARPLUS STSe - Programming & Operations Manual
CO L I N E AT T R I B U T E S
S E L EC T A CO L I NE R A NG E
If HOLD is pressed without entering a CO range, ALL CO lines are selected.
XXX - XXX PAGE C
E N T E R B U T TO N N U MBE R
XXX-XXX = CO Line Range
R I NG DE L AY T I ME R
0 0
00-20
A-9
ICLID / Caller ID
August 2005