Vodavi STARPLUS STSe Operation Manual page 331

T-1 Trunking
5. Press the T-1 SIGNALING flexible button (FLASH 40, Page B, Button #1). The following
message displays:
6. Enter a valid number (0-7) on the dial pad that corresponds to one of the following types:
Signaling Option
[0] = None
[1] = Data (future)
[2] = Loop Start
[3] = Ground Start
[4] = DID
[5] = TIE
[6] = TIE/DNIS
[7] = TIE/ANI
7. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT ... T-1 Signal Type option is Loop Start.
STARPLUS STSe - Programming & Operations Manual
T - 1 S I G NA L T YP E
LO O P S TA R T
Table 2-25: T-1 Signaling Options
Description
None is used for fractional T-1 spans. All unused channels in a
fractional T-1 span should be marked as None.
Disconnect supervision is not supported for Loop Start
emulation of T-1 circuits.
Software supports disconnect supervision for ground start
emulation of T-1 circuits.
The DID signaling (wink, delay, and immediate) is controlled in
Flash 40. DID digits from the carrier are routed via the DID
table. To program the DID table, refer to Flash 44
page 2-112
programming on
page 2-112
on .
This is used for point-to-point T-1 applications.
The DNIS signaling (wink, delay, and immediate) is controlled
in Flash 40. DNIS digits from the carrier are routed via the DID
table. To program the DID table, refer to Flash 44
page 2-112
programming on
page 2-112
on .
The ANI number is treated and routed as an ICLID number. It
follows the Flash 43 programming (
information and Flash 55 programming (
Name/Number Translation.
0-7
and to Flash 43 programming
and to Flash 43 programming
page 2-112
) for routing
page 2-233
) for
2-307
Features and Operation
August 2005