Vodavi STARPLUS STSe Operation Manual page 573

Programming the Voice Mail System
Starting the In-Skins Admin Program ...
If you cannot start the In-Skins Admin program:
»
Make sure your cable connections are secure.
»
Verify that the COM port settings in Windows "Control Panel" have a baud rate of 115,200.
Shutting Down and Resetting the System ...
The "reset button" on the voice mail card will allow you to reset the voice mail system, but
not the KSU. This button is located between the network jack and the serial port jack.
HyperTerminal Boot Up Messages
During the boot up sequence (after the Windows o/s has loaded), the PathFinder boot steps
are executed. During this time, the system will send small information messages out through
the RS-232 port at a speed of 115.2k, N, 8, 1.
If you connect a PC running a terminal communications program (e.g., HyperTerminal), you
will see system messages similar to the following:
2004.06.30 15:01:14 Starting system
2004.06.30 15:01:16 EWF Restore
2004.06.30 15:01:20 Checking for updates
2004.06.30 15:01:22 Starting DigiTalk drivers
2004.06.30 15:01:24 Registering all components
2004.06.30 15:01:26 Reindexing data files
2004.06.30 15:01:37 Creating folders and configuring IP
2004.06.30 15:02:21 Starting PathFinder
2004.06.30 15:02:22 Starting DataServer
STARPLUS STSe - Programming & Operations Manual
D-55
Hard Drive-Based Voice Mail
August 2005