Show Range - Dell Z9500 Reference Manual

Interface index is 1107787786
Internet address is not set
Mode of IPv4 Address Assignment: NONE
DHCP Client-ID: 90b11cf499ce
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d17h26m
Queueing strategy: fifo
Time since last interface status change: 2d17h26m
Input Statistics:
Output Statistics:
Related show interfaces
Commands interface.

show range

Display all interfaces configured using the interface range command.
Z9500
Syntax
show range
Command INTERFACE RANGE (config-if-range)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
850
0 packets, 0 bytes
0 packets, 0 bytes, 0 underruns
— displays information on a specific physical interface or virtual
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4093 VLANs on E-Series ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
Interfaces