This chapter describes the Routing Protocol Configuration set of commands and how to use them.
ROUTER: The commands covered in this chapter can be executed only when the
device is in router mode. For details on how to enable router configuration modes, refer
to
Section
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1. Activating advanced routing features
2. Configuring RIP
3. Configuring OSPF
4. Configuring DVMRP
5. Configuring IRDP
6. Configuring VRRP
NOTE: The command prompts used in examples throughout this guide show a system
where module (or standalone device) 1 and VLAN 1 have been configured for routing.
The prompt changes depending on your current configuration mode, the specific
module, and the interface types and numbers configured for routing on your system.
Routing Protocol Configuration
2.3.3.
(Section
13.2.2)
(Section
13.2.3)
(Section
13.2.4)
(Section
13.2.5)
(Section
13.2.6)
(Section
13.2.1)
Matrix NSA Series Configuration Guide
13
13-1