Ip Irdp Holdtime - Enterasys N Standalone (NSA) Series Configuration Manual

13.2.5.4

ip irdp holdtime

Use this command to set the length of time in seconds IRDP advertisements are held valid.
ip irdp holdtime holdtime
NOTE: Hold time is automatically set at three times the maxadvertinterval value when
the maximum advertisement interval is set as described in
minimum advertisement interval is set as described in
Syntax Description
holdtime
Command Syntax of the "no" Form
The "no" form of this command resets the hold time to the default value of three
times the maxadvertinterval value:
no irdp holdtime
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the IRDP hold time to 4000 seconds on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip irdp holdtime 4000
Routing Protocol Configuration Command Set
Specifies the hold time in seconds. Valid values are 0 to
9000.
Matrix NSA Series Configuration Guide
Configuring IRDP
Section 13.2.5.2
Section 13.2.5.3.
and the
13-85