Enterasys N Standalone (NSA) Series Configuration Manual page 1123

13.2.3.28 show ip ospf virtual-links
Use this command to display information about the virtual links configured on a router. A virtual
link represents a logical connection between the backbone and a non-backbone OSPF area.
show ip ospf virtual-links
Syntax Description
None.
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
None.
Example
This example shows how to display OSPF virtual links information:
Matrix>Router1#show ip ospf virtual-links
Virtual Link to router 5.5.5.1, is UP
Transit area 0.0.0.2,via interface Vlan 7, Cost of using 10
Transmit Delay is 1 sec(s), State POINT-TO-POINT
Timer intervals configured:
Adjacency State FULL
Table 13-6
Table 13-6 show ip ospf virtual links Output Details
Output
Virtual Link
Transit area
via interface
Cost of using
Hello 10, Dead 40, Wait 40, Retransmit 5
provides an explanation of the command output.
What It Displays...
ID of the virtual link neighbor, and the virtual link status,
which is up or down.
ID of the transit area through which the virtual link is
configured.
Router's interface into the transit area.
OSPF cost of routing through the virtual link.
Routing Protocol Configuration Command Set
Matrix NSA Series Configuration Guide
Configuring OSPF
13-71