Routing Protocol Configuration Command Set
Configuring OSPF
13.2.3.3
router id
Use this command to set the OSPF router ID for the device. The OSPF protocol uses the router ID
as a tie-breaker for path selection. If not specified, this will be set to the lowest IP address of the
interfaces configured for IP routing.
router id ip-address
Syntax Description
ip-address
Command Syntax of the "no" Form
The "no" form of this command resets the router ID to the first interface configured
for IP routing:
no router id
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to set the OSPF router ID to IP address 182.127.62.1:
Matrix>Router1(config-router)#router id 182.127.62.1
13-36 Matrix NSA Series Configuration Guide
Specifies the IP address that OSPF will use as the router ID.