Enterasys N Standalone (NSA) Series Configuration Manual page 1058

Routing Protocol Configuration Command Set
Configuring RIP
13.2.2.3 neighbor
Use this command to instruct the router to send unicast RIP information to an IP address. RIP is
normally a broadcast protocol. In order for RIP routing updates to reach nonbroadcast networks, the
neighbor's IP address must be configured to permit the exchange of routing information.
neighbor ip-address
Syntax Description
ip-address
Command Syntax of the "no" Form
The "no" form of this command disables point-to-point routing exchanges:
no neighbor ip-address
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to instruct the system to exchange routing information with neighbor
192.5.10.1:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#neighbor 192.5.10.1
13-6 Matrix NSA Series Configuration Guide
Specifies the IP address of a directly connected neighbor
with which RIP will exchange routing information.