Router Ospf - Enterasys N Standalone (NSA) Series Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF
13.2.3.1

router ospf

Use this command to enable or disable Open Shortest Path First (OSPF) configuration mode.
router ospf process-id
NOTES: You must execute the router ospf command to enable the protocol before
completing many OSPF-specific configuration tasks. For details on enabling
configuration modes, refer to
Only one OSPF process (process-id) is allowed per Matrix Series routing module or
standalone device.
Syntax Description
process-id
Command Syntax of the "no" Form
The "no" form of this command disables OSPF configuration mode:
no router ospf process-id
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to enable routing for OSPF process 1:
Matrix>Router1#conf terminal
Matrix>Router1(config)#router ospf 1
Matrix>Router1(config-router)#
13-34 Matrix NSA Series Configuration Guide
Table 2-9 in Section
Specifies the process ID, an internally used identification
number for an OSPF routing process run on a router. Only
one OSPF process is allowed per device. Valid values are 1
to 65535.
2.3.3.