Ip Rip Authentication Keychain - Enterasys N Standalone (NSA) Series Configuration Manual

13.2.2.14 ip rip authentication keychain

Use this command to enable or disable a RIP authentication key chain for use on an interface.
ip rip authentication keychain name
NOTE: A RIP authentication keychain must be enabled with this command before the
RIP authentication mode
Syntax Description
name
Command Syntax of the "no" Form
The "no" form of this command prevents RIP from using authentication:
no ip rip authentication keychain name
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Examples
This example shows how to set the RIP authentication key chain to "password" on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip authentication keychain password
(Section 13.2.2.15) can be configured.
Specifies the key chain name to enable or disable for RIP
authentication.
Matrix NSA Series Configuration Guide
Routing Protocol Configuration Command Set
Configuring RIP
13-21