Ip Irdp Address - Enterasys N Standalone (NSA) Series Configuration Manual

13.2.5.6

ip irdp address

Use this command to add additional IP addresses for IRDP to advertise.
ip irdp address ip-address preference
Syntax Description
ip-address
preference
Command Syntax of the "no" Form
The "no" form of this command clears an IP address from being advertised:
no ip irdp preference ip-address
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to advertise IP address 183.255.0.162 with a preference of 1 on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip irdp address 183.255.0.162 1
Routing Protocol Configuration Command Set
Specifies an IP address to advertise.
Specifies the value to indicate the address' use as a
default router address. Valid values are -2147483648 to
2147483647. The value of 80000000 indicates that the
address, even though it may be advertised, is not to be
used by neighboring hosts as a default router address.
Matrix NSA Series Configuration Guide
Configuring IRDP
13-87