Ip Rip Receive Version - Enterasys N Standalone (NSA) Series Configuration Manual

Routing Protocol Configuration Command Set
Configuring RIP
13.2.2.8

ip rip receive version

Use this command to set the RIP version(s) for update packets accepted on the interface.
ip rip receive version {1 | 2 | 1 2 | none}
Syntax Description
1
2
1 2
none
Command Syntax of the "no" Form
The "no" form of this command restores the default version of the RIP module
update packets that are accepted on the interface:
no ip rip receive version
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the RIP receive version to 2 for update packets received on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip receive version 2
13-12 Matrix NSA Series Configuration Guide
Specifies RIP version 1.
Specifies RIP version 2.
Specifies RIP versions 1 and 2.
Specifies that no RIP routes will be processed on this
interface.