Enterasys N Standalone (NSA) Series Configuration Manual page 1075

13.2.2.16 no auto-summary
Use this command to disable automatic route summarization. By default, RIP version 2 supports
automatic route summarization, which summarizes subprefixes to the classful network boundary
when crossing network boundaries. Disabling automatic route summarization enables CIDR,
allowing RIP to advertise all subnets and host routing information on the Matrix Series device. To
verify which routes are summarized for an interface, use the show ip protocols command as
described in Section
no auto-summary
NOTE: This command is necessary for enabling CIDR for RIP on the Matrix Series
device.
Syntax Description
None.
Syntax to Reverse Command
This form of the command re-enables automatic route summarization:
auto-summary
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to disable RIP automatic route summarization:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#no auto-summary
12.2.6.1.
Routing Protocol Configuration Command Set
Matrix NSA Series Configuration Guide
Configuring RIP
13-23