Ip Ospf Message Digest Key Md - Enterasys N Standalone (NSA) Series Configuration Manual

13.2.3.12 ip ospf message digest key md5

Use this command to enable or disable OSPF MD5 authentication on an interface. This validates
OSPF MD5 routing updates between neighboring routers.
ip ospf message-digest-key keyid md5 key
Syntax Description
keyid
key
Command Syntax of the "no" Form
The "no" form of this command disables MD5 authentication on an interface:
no ip ospf message-digest-key keyid
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable OSPF MD5 authentication on VLAN 1, set the key identifier to
20, and set the password to "passone":
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf message-digest-key 20 md5 passone
Routing Protocol Configuration Command Set
Specifies the key identifier on the interface where MD5
authentication is enabled. Valid values are integers from 1 to
255.
Specifies a password for MD5 authentication to be used
with the keyid. Valid values are alphanumeric strings of up
to 16 bytes.
Matrix NSA Series Configuration Guide
Configuring OSPF
13-45