13.2.4.1
ip dvmrp
Use this command to enable or disable DVMRP on an interface.
ip dvmrp
NOTE: IGMP must be enabled on all VLANs running DVMRP. To do this, use the set
igmp enable command as described in
IGMP querying be enabled on all VLANs running DVMRP. To do this, use the set igmp
query-enable command as described in
Syntax Description
None.
Command Syntax of the "no" Form
The "no" form of this command disables DVMRP:
no ip dvmrp
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable DVMRP on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip dvmrp
Routing Protocol Configuration Command Set
Section
10.4.1.2. It is also recommended that
Section
10.4.2.2.
Matrix NSA Series Configuration Guide
Configuring DVMRP
13-77