Show Ip Dvmrp Route - Enterasys N Standalone (NSA) Series Configuration Manual

13.2.4.3

show ip dvmrp route

Use this command to display DVMRP routing information.
show ip dvmrp route
Syntax Description
None.
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
None.
Example
This example shows how to display DVMRP routing table entries. In this case, the routing table has
5 entries. The first entry shows that the source network 60.1.1.0/24 can be reached via next-hop
router 40.1.1.3. This route has a metric of 2. It has been in the DVMRP routing table for 1 hour, 24
minutes and 2 seconds and will expire in 2 minutes and 3 seconds. It supports flag messages for
verifying neighbors, pruning, generation ID and netmask in prunes and grafts (VPGN):
Routing Protocol Configuration Command Set
Matrix NSA Series Configuration Guide
Configuring DVMRP
13-79