Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 564

ipv6 interface
ra-retrans-timer time
mtu size
retrans-timer time
dad-transmits count
ra-hop-limit count
ra-default-lifetime time
ra-min-interval interval
ra-clock-skew time
enable | disable
ra-send-mtu
page 11-4
Value, in milliseconds, to be placed in the retransmit timer field in
router advertisements sent on this interface. The value zero indicates
that the time is unspecified by the router.
The maximum transmission unit for a tunnel interface. Use the vlan
command's mtu-ip to set for a VLAN.
The amount of time, in milliseconds, between retransmission of a neigh-
bor solicitation during neighbor discovery.
The number of neighbor solocitations to send during Duplicate Address
Detection.
The value placed in the current hop limit field of router advertisements
sent on this interface.
Value, in seconds, to be placed in the router lifetime field in router
advertisements sent on this interface. The time must be zero or between
the value of "ra-max-interval" and 9,000 seconds. A value of zero indi-
cates that the router is not to be used as a default router. The "no ra-
default-lifetime" option will calculate the value using the formula (3 *
ra-max-interval).
Value, in seconds, allowed between the transmission of unsolicited
multicast router advertisements on this interface. The interval must be a
minimum of 3 and not more than .75 times the value of ra-max-inter-
val.The "no ra-min-interval" option will calculate the value using the
formula (.33 * ra-max-interval).
Value, in seconds. The router advertisement clock skew allows the link
propagation delays and poorly synchronized clocks on routers partici-
pating in router discover over this interface. The timer differences that
fall within the clock skew value are treated as valid times.
Administratively enable or disable the interface.
Specifies whether the MTU option is included in the router advertise-
ments sent on the interface.
OmniSwitch CLI Reference Guide
IPv6 Commands
March 2011