IP Commands
show ip emp-routes
Displays the IP routes associated with the Ethernet Management Port (EMP).
show ip emp-routes
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command displays the routes that are connected to the Ethernet Management Port (EMP).
•
The EMP cannot handle routing protocols such as RIP or OSPF.
•
The default route for the switch cannot be set up on the EMP.
Examples
-> show ip emp-routes
Dest Address
------------------+-----------------+-----------------+---------+-----------
127.0.0.1
172.17.1.10
output definitions
Dest Addr
Subnet Mask
Gateway Addr
Age
Protocol
Release History
Release 7.1.1; command introduced
OmniSwitch CLI Reference Guide
Subnet Mask
Gateway Addr
255.255.255.255
255.255.255.255
Destination IP address.
Destination IP address IP subnet mask.
IP address of the gateway from which this address was learned.
Age of the entry. If the entry is less than a day old, it is displayed in
hh/mm/ss format. If it is more than a day old, it is displayed in dd/hh
format (e.g., a route that is 2 days and 12 hours old is displayed as
2d12h).
Protocol by which this IP address was learned (e.g., RIP). NETMGT
indicates a static route. LOCAL indicates a local interface.
March 2011
Age
127.0.0.1
10.255.11.225
show ip emp-routes
Protocol
2d 4h
LOCAL
1d 5h
LOCAL
page 10-115