Danfoss VLT AutomationDrive FC 301 Programming Manual page 93

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Setting this parameter sets the following parameters to their default settings:
Parameter 1-15 Low Speed Filter Time Const.
l
Parameter 1-16 High Speed Filter Time Const.
l
Parameter 1-17 Voltage Filter Time Const.
l
Parameter 1-24 motor Current
l
Parameter 1-30 Stator Resistance (Rs)
l
Parameter 1-31 Rotor Resistance (Rr)
l
Parameter 1-33 Stator Leakage Reactance (X1)
l
Parameter 1-34 Rotor Leakage Reactance (X2)
l
Parameter 1-35 Main Reactance (Xh)
l
Parameter 1-36 Iron Loss Resistance (Rfe)
l
Parameter 4-18 Current Limit
l
Parameter 14-31 Current Lim Ctrl, Integration Time
l
Parameter 14-43 Motor Cosphi
l
Parameter 16-36 Inv. Nom. Current
l
Parameter 16-37 Inv. Max. Current
l
Parameter 45-33 Alarm High
l
Parameter 45-62 Load Threshold
l
Enter the nominal motor voltage according to the motor nameplate data. The default value corresponds to the nominal rated output of
the unit.
1-23 Motor Frequency
Default value: –
Setup: All setups
Data type: Uint16
From software version 6.72 onwards, the output frequency of the drive is limited to 590 Hz.
© 2024.09
NOTICE
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter Descriptions
Range, 20 - 1000 Hz
0
False
AU275636650261en-003201 / 130R0334 | 93