Danfoss VLT AutomationDrive FC 301 Programming Manual page 344

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Data type: Uint8
This parameter cannot be adjusted while the motor is running.
Option
[0]*
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
8-46 BTM Transaction Status
Default value: [0] Off
Setup:
All setups
Data type: Uint8
344 | © 2024.09
NOTICE
Name
Off
Write to active setup
Commit transaction
Clear error
Write to setup 1
Write to setup 2
Write to setup 3
Write to setup 4
Cancel BTM transaction
Change during operation:
Description
Commit all parameters that have been sent during BTM
mode.
When parameter 8-46 BTM Transaction Status shows
an error (3–8), the parameter must be cleared by
setting this value.
This option is only available with software
version 9.XX.
This option is only available with software
version 9.XX.
This option is only available with software
version 9.XX.
This option is only available with software
version 9.XX.
This option is only available with software
version 9.XX.
Abort any BTM activity. Parameters are not committed.
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
False
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
Option
–
True
AU275636650261en-003201 / 130R0334