Danfoss VLT AutomationDrive FC 301 Programming Manual page 564

Programming Guide | VLT® AutomationDrive FC 301/FC 302
16-45 Motor Phase U Current
Default value: 0 A
Setup: All setups
Data type: Int32
Shows the motor phase U
RMS
imbalance in motor windings.
16-46 Motor Phase V Current
Default value:
0 A
Setup: All setups
Data type:
Int32
Shows the motor phase V
RMS
imbalance in motor windings.
16-47 Motor Phase W Current
Default value: 0 A
Setup: All setups
Data type: Int32
Shows the motor phase W
RMS
imbalance in motor windings.
16-48 Speed Ref. After Ramp [RPM]
Default value: 0 RPM
Setup:
All setups
Data type: Int32
This parameter specifies the reference given to the drive after the speed ramp.
16-49 Current Fault Source
Default value: 0
Setup: All setups
Data type: Uint8
Value indicates source of current faults including short circuit, overcurrent, and imbalance of supply voltage (from left):
1–4 Inverter
l
5–8 Rectifier
l
0 No fault recorded
l
564 | © 2024.09
current. Facilitates monitoring of imbalance in the motor currents, detection of weak motor cables or
current. Facilitates monitoring of imbalance in the motor currents, detection of weak motor cables or
current. Facilitates monitoring of imbalance in the motor currents, detection of weak motor cables or
Parameter type:
Conversion index:
Change during operation.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, 0 - 10000 A
-2
True
Range, 0 - 10000 A
-2
True
Range, 0 - 10000 A
-2
True
Range, -30000 - 30000 RPM
67
False
Range, 0 - 8
0
True
AU275636650261en-003201 / 130R0334