Danfoss VLT AutomationDrive FC 301 Programming Manual page 212

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Table 31: Digital Inputs, Function Descriptions - 4
Option
[107] Target inverse
[108] Enable master offset
[109] Enable. vir.master
[110] Start homing
[111] Activate touch
[112] Relative position
212 | © 2024.09
(continued)
Function
This option is only available with software version 48.XX.
Changes the sign of the set target position. For example, if the
set target is 1000, the activation of this option changes the value
to -1000.
This option is only available with software version 48.XX.
Activates the master offset selected in parameter 3-26 Master
Offset when parameter 17-93 Master Offset Selection has a selec-
tion from [1] Absolute to [5] Relative Touch Sensor.
This option is only available with software version 48.XX.
Enable signal for the virtual master function. Only applicable
when option [10] Synchronization is selected in parameter 1-00
Configuration Mode.
This option is only available with software version 48.XX.
Starts the homing function selected in parameter 17-80 Homing
Function. Must remain high until homing is done, otherwise
homing is aborted.
This option is only available with software version 48.XX.
Activates monitoring of the touch sensor input.
This option is only available with software version 48.XX.
This option selects between absolute and relative positioning.
The option is valid for the next positioning command.
Parameter Descriptions
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
AU275636650261en-003201 / 130R0334