12-4* Fieldbus Extension; 12-5* Ethercat - Danfoss VLT AutomationDrive FC 301 Programming Manual

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Table 43: 16-Bit Status Word, Modbus TCP
Bit
11
12
13
14
15
12-41 Slave Message Count
Default value: 0
Setup:
All setups
Data type: Uint16
This parameter is read-only. It shows the number of Modbus messages received and processed by the follower drive.
12-42 Slave Exception Message
Default value: 0
Setup: All setups
Data type: Uint32
This parameter is read-only. It shows the number of Modbus messages for which the follower has sent an exception response.
6.13.6

12-4* Fieldbus Extension

12-49 Ethernet Extended Status
Default value: 0
Setup:
1 setup
Data type: Uint32
This parameter provides extra information from Ethernet-based communication.

12-5* EtherCAT

6.13.7
12-50 Configured Station Alias
Default value: 0
Setup: 1 setup
Data type: Uint16
Changes are first active after a power cycle. If the DIP switches are all set to ON or all to OFF, the display setting has priority over the DIP
switch. Otherwise, the DIP switch settings have priority over the parameter. In this case, the parameter reflects the setting of the DIP
switches. Changes to the DIP switch setting are active after a power-up.
408 | © 2024.09
(continued)
Description
HTTP server
SMTP server
Cable diagnosis
Auto crossover
IPMG
Bit = [0]
Disabled
Disabled
Disabled
Disabled
Disabled
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Bit = [1]
Enabled
Enabled
Enabled
Enabled
Enabled
Range, 0 - 0
0
True
Range, 0 - 0
0
True
Range, 0 - 0xFFFFFFFF, Array
[8]
0
True
Range, 0 - 65535
0
False
AU275636650261en-003201 / 130R0334