Danfoss VLT AutomationDrive FC 301 Programming Manual page 610

Programming Guide | VLT® AutomationDrive FC 301/FC 302
18-71 Mains Frequency
Default value: 0 Hz
Setup: All setups
Data type: Int16
Shows the mains frequency.
18-72 Mains Imbalance
Default value: 0%
Setup:
All setups
Data type: Uint16
Shows the maximum imbalance for the 3 mains line-to-line measurements.
18-73 Worst Inrush
Default value: 0
Setup: All setups
Data type: Uint16
This parameter identifies which active inrush produces the data shown in parameter 18-70 Mains Voltage, parameter 18-71 Mains
Frequency, parameter 18-72 Mains Imbalance, and parameter 18-75 Rectifier DC Volt. 1 = inrush 1, 2 = inrush 2, and so on.
18-74 Inrush Mode
Default value: 0
Setup:
All setups
Data type: Uint16
This parameter shows the reported mode of each inrush board. The values are:
0 = unknown
l
1 = inrush
l
2 = running
l
The indices are as follows:
0 = inrush1
l
1 = inrush2
l
2 = inrush3
l
3 = inrush4
l
18-75 Rectifier DC Volt
Default value: 0 V
Setup:
All setups
Data type: Uint16
610 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, -100 - 100 Hz
-1
True
Range, 0 - 100%
-1
True
Range, 0 - 10000
0
True
Range, 0 - 1000, Array [4]
0
True
Range, 0 - 10000 V
0
True
AU275636650261en-003201 / 130R0334