Danfoss VLT AutomationDrive FC 301 Programming Manual page 136

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[4] Warning 30s
[5] Trip 30s
[6] Warning & trip 30s
[7] Warning 60s
[8] Trip 60s
[9] Warning & trip 60s
[10] Warning 300s
[11] Trip 300s
[12] Warning & trip 300s
[13] Warning 600s
[14] Trip 600s
[15] Warning & trip 600s
2-14 Brake Voltage Reduce
Default value: 0
Setup:
All setups
Data type: Uint16
This parameter can reduce the DC voltage where the brake resistor is active. It is only valid for T4 units. Setting this parameter may
change the brake resistor (parameter 2-11 Brake Resistor (ohm)).
136 | © 2024.09
Description
Activates a warning on the display when the power transmitted
during the duty time exceeds 100% of the monitoring limit
(parameter 2-12 Brake Power Limit (kW)). The warning
disappears when the transmitted power drops below 80% of the
monitoring limit.
Trips the drive and shows an alarm when the calculated power
exceeds 100% of the monitoring limit.
Activates both of the above, including warning and alarm.
Activates a warning on the display when the power transmitted
during the duty time exceeds 100% of the monitoring limit
(parameter 2-12 Brake Power Limit (kW)). The warning
disappears when the transmitted power drops below 80% of the
monitoring limit.
Trips the drive and shows an alarm when the calculated power
exceeds 100% of the monitoring limit.
Activates both of the above, including warning and alarm.
Activates a warning on the display when the power transmitted
during the duty time exceeds 100% of the monitoring limit
(parameter 2-12 Brake Power Limit (kW)). The warning
disappears when the transmitted power drops below 80% of the
monitoring limit.
Trips the drive and shows an alarm when the calculated power
exceeds 100% of the monitoring limit.
Activates both of the above, including warning and alarm.
ctivates a warning on the display when the power transmitted
during the duty time exceeds 100% of the monitoring limit
(parameter 2-12 Brake Power Limit (kW)). The warning
disappears when the transmitted power drops below 80% of the
monitoring limit.
Trips the drive and shows an alarm when the calculated power
exceeds 100% of the monitoring limit.
Activates both of the above, including warning and alarm.
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, 0 - 200 V
0
True
AU275636650261en-003201 / 130R0334