Danfoss VLT AutomationDrive FC 301 Programming Manual page 602

Programming Guide | VLT® AutomationDrive FC 301/FC 302
18-04 Mech Brake Count
Default value: 0
Setup: All setups
Data type: Uint32
Number of times the mechanical brake has been engaged.
18-1* Emergency Mode Log
6.19.2
The emergency log covers operation of emergency mode with start and stop activities and if critical alarms are suppressed during
emergency mode. The log contains the 10 latest activations of emergency mode or the alarm number of the critical alarm that was
suppressed as this affects the warranty of the drive. Suppressed alarm numbers are stored and can only be reset by a Danfoss service
inspection.
18-10 Emergency Mode Log: Event
Default value:
0
Setup: All setups
Data type:
Uint16
This parameter contains an array with 10 elements. The number read represents a fault code, which corresponds to a specific alarm. Refer
to Alarm/Warning Code Listin chapter Troubleshooting.
18-11 Emergency Mode Log: Time
Default value: 0 s
Setup: All setups
Data type:
Uint32
This parameter shows at which time the logged event occurred. Time is measured in seconds since the drive was started.
18-12 Emergency Mode Log: Date and Time
Default value: Size related
Setup: All seutps
Data type:
TimeOfDay
This parameter shows at which date and time the logged event occurred. The date and time rely on the internal clock in parameter group
0-7* Clock Settings.
18-1* Parameter Log
6.19.3
18-13 Parameter Number
Default value: 0 N/A
Setup:
All setups
602 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Parameter Descriptions
Range, 0 - 4294967295
0
False
Range, 0 - 255, Array [10]
0
False
Range, 0 - 2147483647 s, Array
[10]
0
False
Range, Size related, Array [10]
0
False
Range, 0 - 0xFFFF N/A, Array
[10]
0
AU275636650261en-003201 / 130R0334