Danfoss VLT AutomationDrive FC 301 Programming Manual page 562

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Data type: Uint8
View the drive heat sink temperature. The cutout limit is 90 ±5 °C (194 ±9 °F), and the motor cuts back in at 60 ±5 °C (140 ±9 °F).
16-35 Inverter Thermal
Default value:
0%
Setup: All setups
Data type:
Uint8
View the percentage load on the inverter.
16-36 Inv. Nom. Current
Default value: Size related
Setup: All setups
Data type: Uint32
View the inverter nominal current, which must match the nameplate data on the connected motor. The data is used for calculation of
torque, motor overload protection, and so on.
16-37 Inv. Max. Current
Default value:
Size related
Setup: All setups
Data type:
Uint32
View the inverter maximum current, which must match the nameplate data on the connected motor. The data is used for calculation of
torque, motor overload protection, and so on.
16-38 SL Controller State
Default value: 0
Setup: All setups
Data type: Uint8
View the state of the event under execution by the SL controller.
16-39 Control Card Temp.
Default value:
0 °C
Setup: All setups
Data type:
Uint8
View the temperature on the control card, stated in °C.
16-40 Logging Buffer Full
Default value: [0] No
562 | © 2024.09
Change during operation:
Parameter type:
Conversion index:
Conversion index:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter Type:
Parameter Descriptions
False
Range, 0 - 100%
0
False
Range, 0.01 - 10000 A
-2
False
Range, 0.01 - 10000 A
-2
False
Range, 0 - 100, Array [4]
0
False
Range, 0 - 100 °C
100
False
Option
AU275636650261en-003201 / 130R0334