Ext. Process Pid Ctrl - Danfoss VLT AutomationDrive FC 301 Programming Manual

Programming Guide | VLT® AutomationDrive FC 301/FC 302
7-46 Process PID Feed Fwd Normal/Inv. Ctrl.
Default value: [0] Normal
Setup: All setups
Data type: Uint8
Option Name
[0]* Normal
[1] Inverse
7-48 PCD Feed Forward
Default value: 0
Setup: All setups
Data type: Uint16
This parameter contains the value of parameter 7-45 Process PID Feed Fwd Resource, [32] Bus PCD.
7-49 Process PID Output Normal/Inv. Ctrl.
Default value:
[0] Normal
Setup: All setups
Data type:
Uint8
Option Name
[0]* Normal
[1] Inverse

7-5* Ext. Process PID Ctrl.

6.9.8
This parameter group is only used if parameter 1-00 Configuration Mode is set to [7] Extended PID speed CL or [8] Extended PID speed OL.
7-50 Process PID Extended PID
Default value: [1] Enabled
Setup: All setups
Data type: Uint8
310 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Description
Select [0] Normal to set the feed-forward factor to treat the FF
resource as a positive value.
Select [1] Inverse to treat the feed-forward resource as a negative
value.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Select [0] Normal to use the resulting output from the process
PID controller as is.
Select [1] Inverse to invert the resulting output from the process
PID controller. This operation is performed after the feed-forward
factor is applied.
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Option
–
True
Range, 0 - 65535
0
True
Option
–
True
Option
–
True
AU275636650261en-003201 / 130R0334