Danfoss VLT AutomationDrive FC 301 Programming Manual page 540

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[37] Digital input DI32
[38] Digital input DI33
[50] Comparator 4
[51] Comparator 5
[60] Logic rule 4
[61] Logic rule 5
15-13 Logging Mode
Default value:
[0] Log always
Setup: 2 setups
Data type:
Uint8
Option Name
[0]* Log always
[1] Log once on trigger
15-14 Samples Before Trigger
Default value: 50
Setup:
2 setups
Data type: Uint8
Before a trigger event, enter the percentage of all samples which should be retained in the log. See also parameter 15-12 Trigger Event
and parameter 15-13 Logging Mode.
15-15 Info Message: "Service Log Full"
Default value: [0] Disabled
Setup: 1 setup
Data type: Uint8
See Service log. By enabling this parameter, a text message is shown in the drive when the service log runs full: Clear logs, Service log full:
28 [M26]. The message recommends to clear the log.
Option Name
[0]* Disabled
[1] Enabled
540 | © 2024.09
Description
Parameter type:
Conversion index:
Change during operation:
Description
Select [0] Log always for continuous logging.
Select [1] Log once on trigger to start and stop logging
conditionally using parameter 15-12 Trigger Event and
parameter 15-14 Samples Before Trigger.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Enable message.
Parameter Descriptions
Option
–
True
Range, 0 - 100
0
True
Option
–
True
AU275636650261en-003201 / 130R0334