Danfoss VLT AutomationDrive FC 301 Programming Manual page 573

Programming Guide | VLT® AutomationDrive FC 301/FC 302
16-88 Fieldbus Torque FF
Default value: 0
Setup: 1 setup
Data type: N2
A PCD write reference parameter. This parameter allows the PLC to adjust the Torque FF over the fieldbus continuously as a percentage
of motor nominal torque, see parameter 1-26 Motor Cont. Rated Torque.
16-89 Configurable Alarm/Warning Word
Default value:
0
Setup: All setups
Data type:
Uint16
This alarm/warning word is configured in parameter 8-17 Configurable Alarm and Warningword to match the actual requirements.
16-9* Diagnosis Readouts
6.17.7
Use the parameters to show alarm, warning, and extended status words.
16-90 Alarm Word
Default value:
0
Setup: All setups
Data type:
Uint32
Show the alarm word sent via the serial communication port in hex code.
16-91 Alarm Word 2
Default value: 0
Setup: All setups
Data type: Uint32
Shows the alarm word sent via the serial communication port in hex code.
16-92 Warning Word
Default value: 0
Setup:
All setups
Data type: Uint32
Shows the warning word sent via the serial communication port in hex code.
16-93 Warning Word 2
Default value: 0
Setup: All setups
© 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Range, -200 - 200
0
True
Range, 0 - 65535
0
False
Range, 0 - 4294967295
0
False
Range, 0 - 4294967295
0
False
Range, 0 - 4294967295
0
False
Range, 0 - 4294967295
0
573