Devicenet - Danfoss VLT AutomationDrive FC 301 Programming Manual

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Setup: All setups
Data type: Uint8
View the number of fieldbus off events since the last power-up.

10-1* DeviceNet

6.12.2
10-10 Process Data Type Selection
Default value:
–
Setup: All setups
Data type: Uint8
Select the instance (telegram) for data transmission. The instances available depend on the setting of parameter 8-10 Control Word
Profile. When parameter 8-10 Control Word Profile is set to [0] FC Profile, options [0] INSTANCE 100/150 and [1] INSTANCE 101/151 in
this parameter are available. When parameter 8-10 Control Word Profile is set to [5] ODVA, options [2] INSTANCE 20/70 and [3] INSTANCE
21/71 in this parameter are available. Instances 100/150 and 101/151 are specific. Instances 20/70 and 21/71 are ODVA-specific AC motor
profiles. For guidelines in telegram selection, refer to the VLT® DeciveNet MCA 104 Installation Guide.
A change to this parameter is executed immediately.
Option Name
[0] Instance 100/150
[1] Instance 101/151
[2] Instance 20/70
[3] Instance 21/71
[6] Instance 102/152
10-11 Process Data Config Write
Default value: Size related
Setup: All setups
Data type: Uint16
Option Name
[0] None
[109] Mode of operation
[302] Minimum reference
[303] Maximum reference
[311] Jog speed [Hz]
© 2024.09
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
Description
Parameter type:
Conversion index:
Change during operation:
Description
Parameter Descriptions
0
True
Option
–
True
Option, Array [4]
–
True
AU275636650261en-003201 / 130R0334 | 375