Danfoss VLT AutomationDrive FC 301 Programming Manual page 255

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[8] Run on ref/no warn
[9] Alarm
[10] Alarm or warning
[11] At torque limit
[12] Out of current range
[13] Below current, low
[14] Above current, high
[15] Out of speed range
[16] Below speed, low
[17] Above speed, high
[18] Out of feedb. range
[19] Below feedback, low
[20] Above feedback, high
[21] Thermal warning
[22] Ready,no thermal W
[23] Remote,ready, no TW
[24] Ready, Voltage OK
[25] Reverse
[26] Bus OK
© 2024.09
Description
The motor runs at reference speed. No warnings.
An alarm activates the output. No warnings.
An alarm or a warning activates the output.
The torque limit set in parameter 4-16 Torque Limit Motor Mode
or parameter 4-17 Torque Limit Generator Mode has been
exceeded.
The motor current is outside the range set in parameter 4-18
Current Limit.
The motor current is lower than set in parameter 4-50 Warning
Current Low.
The motor current is higher than set in parameter 4-51 Warning
Current High.
Output speed/frequency is outside the frequency range set in
parameter 4-52 Warning Speed Low and parameter 4-53 Warning
Speed High.
Output speed is lower than the setting in parameter 4-52
Warning Speed Low.
Output speed is higher than the setting in parameter 4-53
Warning Speed High.
Feedback is outside the range set in parameter 4-56 Warning
Feedback Low and parameter 4-57 Warning Feedback High.
Feedback is below the limit set in parameter 4-56 Warning
Feedback Low.
Feedback is above the limit set in parameter 4-57 Warning
Feedback High.
Thermal warning turns on when the temperature exceeds
the limit either in motor, drive, brake resistor, or connected
thermistor.
The drive is ready for operation and there is no overtemperature
warning.
The drive is ready for operation and is in auto-on mode. There is
no overtemperature warning.
The drive is ready for operation and the mains voltage is within
the specified voltage range.
The motor runs (or is ready to run) clockwise when logic = 0 and
counterclockwise when logic = 1. The output changes as soon as
the reversing signal is applied.
Active communication (no timeout) via the serial communication
port.
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
255