Danfoss VLT AutomationDrive FC 301 Programming Manual page 641

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Setup: All setups
Data type: Int32
This parameter is only available with software version 48.94 or newer.
Select the last position defining the digital CAM switch A.
24-54 On Compensation A
Default value: 0 ms
Setup:
All setups
Data type: Uint16
This parameter is only available with software version 48.94 or newer.
Enables compensation for delay in the component switched by the digital CAM switch output. The drive calculates the distance it will
move within the On compensation time based on the actual speed. The output will be switched on at this distance before the set first or
last position.
24-55 Off Compensation A
Default value:
0 ms
Setup: All setups
Data type:
Uint16
This parameter is only available with software version 48.94 or newer.
Enables compensation for delay in the component switched by the digital CAM switch output. The drive calculates the distance is will
move within the off compensation time based on the actual speed.The output will then be switched off at this distance before the set first
or last position.
24-6* Digi. CAM Switch B
6.23.4
24-60 Switch Source B
Default value:
[0] Actual position
Setup: All setups
Data type:
Uint8
Select the position source for activation of the digital CAM switch B. Digital CAM switch B can be assigned to a digital output using the
selections [102] Digi. CAM switch B or [103] Digi. CAM sw. B inv.
© 2024.09
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
0
True
Range, 0 - 10000 ms
-3
True
Range, 0 - 10000 ms
-3
True
Option
–
True
AU275636650261en-003201 / 130R0334 | 641