Fc Port Diagnostics - Danfoss VLT AutomationDrive FC 301 Programming Manual

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[0] Digital input
[1] Bus
[2] Logic AND
[3]* Logic OR
8-58 PROFIdrive OFF3 Select
Default value: [3] Logic OR
Setup: All setups
Data type: Uint8
Select control of the drive OFF3 selection via the terminals (digital input) and/or via the fieldbus. This parameter is active only when
parameter 8-01 Control Site is set to [0] Digital and ctrl. word and parameter 8-10 Control Word Profile is set to [1] PROFIdrive profile.
Option Name
[0] Digital input
[1] Bus
[2] Logic AND
[3]* Logic OR

8-8* FC Port Diagnostics

6.10.7
This parameter group contains parameters for monitoring the bus communication via the drive RS485 port terminals 68 and 69.
8-80 Bus Message Count
Default value: 0
Setup: All setups
Data type: Uint32
This parameter shows the number of valid telegrams detected on the bus.
8-81 Bus Error Count
Default value: 0
Setup:
All setups
Data type: Uint32
This parameter shows the number of telegrams with faults (for example, CRC fault) detected on the bus.
8-82 Slave Messages Rcvd
Default value: 0
© 2024.09
Description
Parameter type:
Conversion index:
Change during operation:
Description
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Option
–
True
Range, 0 - 0
0
True
Range, 0 - 0, Array [6]
0
True
Range, 0 - 0
349